The sub-point Service > Settings > Base > Signal content replacement allows the configuration of automatic replacements of signal contents.
The ToolScope can receive tool, axis and program names from the control system via the string transmission from the PLC/PMC. In certain cases, however, this procedure is not possible or desirable.
The ToolScope therefore has the possibility of exchanging names transferred from the control system.
Example: If a tool number "1" is transferred, "Thread cutter 8 mm" should be displayed instead. If a tool number "2" is transferred, "Tap hole 6.8 mm" should be displayed instead.
For this purpose, under settings/base/signal content replacement you can enter a list of names to be replaced. Put the original signal contents on the left side and enter the wanted replacement on the right.