menu

TSVNCC has two views since version 20150220. In addition to the standard ToolScope view, there is also a Service view, which you can switch to by pressing "CTRL" + "Up arrow". You can return to the ToolScope screen by pressing "CTRL" + "Up arrow" again.

Otherwise, the Service view is displayed for as long as there is no connection.

 

The following information can be found on the screen (see Figure 57):

  • Connection status: Top-left corner
  • Target IP address: Bottom left, above the box
  • OPC connector status: Third box from the left (Operate)
  • Debug level: Sixth box from the left (only in Debug mode)
  • Debug status: Seventh box from the left

Soft key functions:

  • F1 ("IP address"):
    • Windows/HMI Advanced: Calls up a dialog box, in which the target IP address can be changed. The old connection is then disconnected and a new connection to the new IP is established.
    • Operate: Reloads the target IP address from the ToolScope-ini. The old connection is then disconnected and a new connection to the new IP is established.
  • F6: Increases the debug level from TSVNCC to 1. Level 3 is followed by level 0. A higher debug level results in more messages being written in the log file. (Only visible when debugging is activated)
  • F7: Switches the Debug mode on or off. When debugging is switched off, no log files are created by TSVNCC. During continuous operation, the size of log files is also limited.
  • Only applicable to the Windows version/in HMI Advanced:
  • F8: Closes the program (Windows/HMI Advanced)